The thin film reflects some of the light passing through it. In physics, interference is a phenomenon in which two waves superpose to form a resultant wave of greater, lower, or the same amplitude. Car manufacturers are offering special paint jobs that use thin film interference to produce colors that change with angle. Light, eometrical optics: the lens equation: object distance, image distance and focal length. Thin film is the film whose thickness is of the order of wavelength of the light which is used to expose it. Explanation: No explanation available. Interference in thin films. For other wavelengths condition of minima is satisfied, and so corresponding colours will be missing in the pattern. Be the first to write the explanation for this question by commenting below. Interference can be seen at O by division of amplitude, some light being reflected from each side of the film. Physclips provides multimedia education in introductory physics (mechanics) at different levels. Related Questions: The colours seen in a soap bubble arise from interference of light reflecting off the front & back surfaces of the thin soap film. We will first consider the interference due to a parallel-sided film as shown in Figure 1. Depending on thickness of film, different colours interfere constructively & destructively. Options (a) interference (b) scattering (c) diffraction (d) dispersion. Colours appear on a thin soap film and soap bubbles due to the phenomenon of . Correct Answer: interference. Commercial oil formulations usually contain a surfactant, an additive that causes the oil drops to spread out into a thin film atop the water. The wings of certain moths and butterflies have nearly iridescent colors due to thin film interference. Converging lenses, diverging lenses. The color bands in thin films are a result of wavelength dependent interference caused by the close spacing of the surfaces of the film. Light is reflected from the top and bottom surfaces of a thin film and the reflected rays interfere. The beautiful colours in soap films and in oil floating on water are due to interference by reflection. Thus the light entering at different angles traverses a different path and different wavelengths will be canceled out and reinforced differently at different observation angles. When a thin film is exposed to white light from an extended source, it shows beautiful colours in the reflected system. In addition to pigmentation, the wingâ€™s color is affected greatly by constructive interference of certain wavelengths reflected from its film-coated surface. Colours of thin films: When white light is incident on a thin film only few wavelengths will satisfy the condition of maxima and therefore corresponding colours will seen in the pattern. Soap-bubbles, interference colours, surface tension, minimal shapes Physics with animations and video film clips.